Trim Tabs

EricY · 10-03-2008, 04:48 AM

OK, I'm at the point were I'm planing out how I want to put my challenger back together. If budget allows(or maybe whether it does or not) I'm going to replace my hydralic tabs (not Bennett) with some Lenco's.

So, my question is: Is there any performance difference in the regular mount Lencos compared to the Edge mount?

Thanks
Eric

TroutTouter · 10-11-2008, 08:53 AM

I believe the edge mounts are for applications that have less room on the transom as far as height goes. I would think if the actuators are the same the edge mount would have less travel due to the geometery behind the angle.

10-03-2008, 04:48 AM	#1 (permalink)
EricY Member Join Date: Apr 2007 Location: Deland Posts: 59	Trim Tabs OK, I'm at the point were I'm planing out how I want to put my challenger back together. If budget allows(or maybe whether it does or not) I'm going to replace my hydralic tabs (not Bennett) with some Lenco's. So, my question is: Is there any performance difference in the regular mount Lencos compared to the Edge mount? Thanks Eric

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-11-2008, 08:53 AM	#2 (permalink)
TroutTouter Senior Member Join Date: Aug 2007 Location: Downtown Orlando Posts: 568	I believe the edge mounts are for applications that have less room on the transom as far as height goes. I would think if the actuators are the same the edge mount would have less travel due to the geometery behind the angle.